Sensor The sensor technical information is contained in the ADNS Data Sheet. Lens The lens information is contained in the HDNS/HDNS# ADNS datasheet, ADNS circuit, ADNS data sheet: AVAGO – Optical Mouse Sensor,alldatasheet, datasheet, Datasheet search site for. Kit Components. See table below. Sensor. The sensor technical information is contained in the ADNS Data Sheet. Lens. The lens information is contained.

Author: Meztinris Faelar
Country: Saint Kitts and Nevis
Language: English (Spanish)
Genre: Environment
Published (Last): 21 February 2012
Pages: 228
PDF File Size: 7.27 Mb
ePub File Size: 17.62 Mb
ISBN: 186-8-38763-346-1
Downloads: 48951
Price: Free* [*Free Regsitration Required]
Uploader: Nitaur

The address of the configuration register was moved from 0x0A to 0x PWM is only for 40Hz to 40kHz. Thanks for the answer. I am curious, how can you tell if the chip is producing a 18×18 image?

optical sensor + myrio – Discussion Forums – National Instruments

Datasheeet used a slightly modified version of the circuit described in the c’t Bot Wiki:. So, I finally got the mice I ordered in the mail Let’s start with the old mouse: It’s still my hobby. Datasheet to similar A Can you tell me an advice how can I communicate with this sensor via myRIO?


Physical Construction The pins 5 through 8 were soldered to a small stripboard. They were used later at the end of the assembly. A avns operation consist of 2 Byte.

It sounds like an interesting idea. And wishing I were better in the math department.

I couldn’t have done it without the help of a couple people for sure. Here is the Arduino code Code: With all the soldering I’ve been doing getting those adjs wires to solder on well is difficult I hope that the little chip can take the heat The first Byte has ‘0’ at MSB that indicates that we are reading data and seven bit request data from certain register.

Thanks again for your help!

ADNS-2610 Datasheet

For details, see the following two documents that are available at the Avago web site:. Send Bitcoin sdns to: For details, see the following two documents that are available at the Avago web site: Hello- I wanted to close out this post with the conclusion of this project.

Just wanted to post an update here: The person who was troubleshooting this problem for me couldn’t figure out the solution. Send Bitcoin tips to: I had switched around a few of the pins and the wires, but after I got them straightened out I started to get readings from the serial port!


I have rather the MCS http: I am not sure what I am doing wrong here. The following images shows the result of the assembly seen from top: Two wires were soldered to pin 3 and datwsheet, they were connected to the stripboard.

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. The one near the top is probably a good place to have it. It would be nice to confirm this with your device I do not know what kind of myRIO you have but I would say that your myRIO will handle the optical sensor’s requirements. I come to you no prior knowledge.